|
Git's pack storage does efficient (log n) lookups in a
single packfile's index, but if we have multiple packfiles,
we have to linearly search each for a given object. This
patch introduces some timing tests for cases where we have a
large number of packs, so that we can measure any
improvements we make in the following patches.
The main thing we want to time is object lookup. To do this,
we measure "git rev-list --objects --all", which does a
fairly large number of object lookups (essentially one per
object in the repository).
However, we also measure the time to do a full repack, which
is interesting for two reasons. One is that in addition to
the usual pack lookup, it has its own linear iteration over
the list of packs. And two is that because it it is the tool
one uses to go from an inefficient many-pack situation back
to a single pack, we care about its performance not only at
marginal numbers of packs, but at the extreme cases (e.g.,
if you somehow end up with 5,000 packs, it is the only way
to get back to 1 pack, so we need to make sure it performs
well).
We measure the performance of each command in three
scenarios: 1 pack, 50 packs, and 1,000 packs.
The 1-pack case is a baseline; any optimizations we do to
handle multiple packs cannot possibly perform better than
this.
The 50-pack case is as far as Git should generally allow
your repository to go, if you have auto-gc enabled with the
default settings. So this represents the maximum performance
improvement we would expect under normal circumstances.
The 1,000-pack case is hopefully rare, though I have seen it
in the wild where automatic maintenance was broken for some
time (and the repository continued to receive pushes). This
represents cases where we care less about general
performance, but want to make sure that a full repack
command does not take excessively long.
Signed-off-by: Jeff King <peff@peff.net>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
|
Jeff King