diff options
Diffstat (limited to 't/test-lib.sh')
| -rw-r--r-- | t/test-lib.sh | 46 |
1 files changed, 33 insertions, 13 deletions
diff --git a/t/test-lib.sh b/t/test-lib.sh index e7065df2bb..9a0a21f49a 100644 --- a/t/test-lib.sh +++ b/t/test-lib.sh @@ -80,7 +80,7 @@ done,*) # from any previous runs. >"$GIT_TEST_TEE_OUTPUT_FILE" - (GIT_TEST_TEE_STARTED=done ${SHELL_PATH} "$0" "$@" 2>&1; + (GIT_TEST_TEE_STARTED=done ${TEST_SHELL_PATH} "$0" "$@" 2>&1; echo $? >"$BASE.exit") | tee -a "$GIT_TEST_TEE_OUTPUT_FILE" test "$(cat "$BASE.exit")" = 0 exit @@ -264,7 +264,6 @@ do shift ;; -x) trace=t - verbose=t shift ;; --verbose-log) verbose_log=t @@ -283,6 +282,11 @@ then test -z "$verbose_log" && verbose=t fi +if test -n "$trace" && test -z "$verbose_log" +then + verbose=t +fi + if test -n "$color" then # Save the color control sequences now rather than run tput @@ -586,7 +590,9 @@ maybe_setup_valgrind () { } want_trace () { - test "$trace" = t && test "$verbose" = t + test "$trace" = t && { + test "$verbose" = t || test "$verbose_log" = t + } } # This is a separate function because some tests use @@ -601,26 +607,40 @@ test_eval_inner_ () { } test_eval_ () { - # We run this block with stderr redirected to avoid extra cruft - # during a "-x" trace. Once in "set -x" mode, we cannot prevent + # If "-x" tracing is in effect, then we want to avoid polluting stderr + # with non-test commands. But once in "set -x" mode, we cannot prevent # the shell from printing the "set +x" to turn it off (nor the saving # of $? before that). But we can make sure that the output goes to # /dev/null. # - # The test itself is run with stderr put back to &4 (so either to - # /dev/null, or to the original stderr if --verbose was used). + # There are a few subtleties here: + # + # - we have to redirect descriptor 4 in addition to 2, to cover + # BASH_XTRACEFD + # + # - the actual eval has to come before the redirection block (since + # it needs to see descriptor 4 to set up its stderr) + # + # - likewise, any error message we print must be outside the block to + # access descriptor 4 + # + # - checking $? has to come immediately after the eval, but it must + # be _inside_ the block to avoid polluting the "set -x" output + # + + test_eval_inner_ "$@" </dev/null >&3 2>&4 { - test_eval_inner_ "$@" </dev/null >&3 2>&4 test_eval_ret_=$? if want_trace then set +x - if test "$test_eval_ret_" != 0 - then - say_color error >&4 "error: last command exited with \$?=$test_eval_ret_" - fi fi - } 2>/dev/null + } 2>/dev/null 4>&2 + + if test "$test_eval_ret_" != 0 && want_trace + then + say_color error >&4 "error: last command exited with \$?=$test_eval_ret_" + fi return $test_eval_ret_ } |